Remedy Ultra

A triclopyr herbicide for labeled pasture, rangeland and brush-control uses in the 1 gallon jug.

A tool for woody plants and broadleaf weeds

Remedy Ultra is a triclopyr herbicide used for brush control and listed broadleaf weeds in pasture, rangeland, forestry and other approved sites. Corteva’s label names species such as blackberry, multiflora rose, poison ivy and oak, and selected woody plants. It is chosen when the problem is brush or broadleaf vegetation that a pasture manager wants to control while maintaining labeled grass uses. It is not the same formula as original Remedy.

Liquid ester concentrate for several methods

The product is a liquid concentrate with 60.45% triclopyr ester. The label provides methods including foliar spray and woody-stem treatments, with separate directions for broadcast, high-volume and individual-plant work. That flexibility helps a manager match treatment to patch size: broad areas may need a broadcast approach, while scattered brush may call for individual plant treatment. Choose the method that is listed for the target and site.

Foliar treatment versus woody stems

For leafy brush, a foliar application reaches the plant’s leaves during active growth. For some woody targets, the label provides cut-stump or basal-bark methods that place treatment on exposed or lower stem surfaces. These approaches serve different situations. A field edge with a few shrubs is not the same task as a pasture with a broadleaf weed patch, and each label method has specific concentration and timing requirements.

Foliar coverage has a seasonal setting

For foliar work, the label relates treatment to actively growing plants and adequate foliage. A woody plant with little leaf area presents a different opportunity from a fully leafed-out shrub. Stress and seasonal growth can influence response, so a lack of immediate browning is not the only measure of a systemic brush treatment. The target-specific method is more useful than choosing a general concentration for every species.

A different formulation from original Remedy

Remedy Ultra contains 60.45% triclopyr butoxyethyl ester, equivalent to four pounds of triclopyr acid per gallon. That identifies the product without borrowing original Remedy's 61.6% formulation. The Ultra label describes movement within susceptible plants, which helps explain its role on established woody vegetation. Leaves, bark and freshly cut stems provide different treatment opportunities; the appropriate one depends on the species and whether the brush is standing, leafy or already cut.

Directions for use

Directions for Use It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read all Directions for Use carefully before applying.

Mixing Directions Remedy Ultra specialty herbicide may be foliarly applied by diluting with water or by preparing an oil-water emulsion. For woody plant control, an oil-water emulsion performs more dependably under a broader range of conditions than a straight water dilution and is recommended for aerial applications.

Complete product label with site-specific directions, rates, application tables and restrictions: https://www.cdms.net/ldat/ld7NR012.pdf

Cautions

Precautionary Statements Hazards to Humans and Domestic Animals EPA Reg. No. 62719-552 Keep Out of Reach of Children CAUTION Causes Moderate Eye Irritation • Harmful If Swallowed • Prolonged Or Frequently Repeated Skin Contact May Cause Allergic Reactions In Some Individuals Avoid contact with eyes, skin, or clothing. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet. Personal Protective Equipment (PPE) Applicators and other handlers must wear: • Long-sleeved shirt and long pants • Waterproof gloves • Shoes plus socks Follow the manufacturer's instructions for cleaning/maintaining PPE. If no such instructions for washables, use detergent and hot water. Keep and wash PPE separately from other laundry. User Safety Recommendations Users should: • Wash hands thoroughly with soap and water before eating, drinking, chewing gum, using tobacco, or using the toilet. • Remove clothing/PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing. First Aid If in eyes: Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a poison control center or doctor for treatment advice. If on skin or clothing: Take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. Call a poison control center or doctor for treatment advice. First Aid (Cont.) If swallowed: Call a poison control center or doctor immediately for treatment advice. Have person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by a poison control center or doctor. Do not give anything by mouth to an unconscious person. Have the product container or label with you when calling a poison control center or doctor, or going for treatment. You may also contact 1-800-992-5994 for emergency medical treatment information. Environmental Hazards This pesticide is toxic to fish. Do not apply directly to water, to areas where surface water is present, or to intertidal areas below the mean high water mark. Do not contaminate water when cleaning equipment or disposing of equipment washwaters. This chemical has properties and characteristics associated with chemicals detected in groundwater. The use of this chemical in areas where soils are permeable, particularly where the water table is shallow, may result in groundwater contamination.

Agricultural Use Requirements Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR part 170. This Standard contains requirements for the protection of agricultural workers on farms, forests, nurseries, and greenhouses, and handlers of agricultural pesticides. It contains requirements for training, decontamination, notification, and emergency assistance. It also contains specific instructions and exceptions pertaining to the statements on this label about personal protective equipment (PPE), and restricted entry interval. The requirements in this box only apply to uses of this product that are covered by the Worker Protection Standard. Do not enter or allow worker entry into treated areas during the restricted entry interval (REI) of 12 hours. PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated, such as plants, soil, or water, is: • Coveralls • Waterproof gloves • Shoes plus socks • Protective eyewear Non-Agricultural Use Requirements The requirements in this box apply to uses of this product that are NOT within the scope of the Worker Protection Standard for Agricultural Pesticides (40 CFR Part 170). The WPS applies when this product is used to produce agricultural plants on farms, forests, nurseries, or greenhouses. Entry Restrictions for Non-WPS Uses: Keep unprotected persons out of treated areas until sprays have dried.

Storage and Disposal Do not contaminate water, food, or feed by storage and disposal. Open dumping is prohibited. Pesticide Storage: Store above 28°F or agitate before use. Pesticide Disposal: Wastes resulting from the use of this product must be disposed of on site or at an approved waste disposal facility. Nonrefillable containers 5 gallons or less: Container Handling: Nonrefillable container. Do not reuse or refill this container. Offer for recycling if available or puncture and dispose of in a sanitary landfill, or by incineration, or by other procedures allowed by state and local authorities. Triple rinse or pressure rinse container (or equivalent) promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank. Fill the container 1/4 full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Pressure rinse as follows: Empty the remaining contents into application equipment or a mix tank. Hold container upside down over application equipment or mix tank or collect rinsate for later use or disposal. Insert pressure rinsing nozzle in the side of the container, and rinse at about 40 psi for at least 30 seconds. Drain for 10 seconds after the flow begins to drip.